Wireless Camera 2.0 Setup Guide

Equipment Overview:

Endzone Kit:

Endzone Tower Setup

30' Tower Setup

Insert the tower into the base plate with wheels and then extend all 4 locking legs:

Then tighten all 4 knobs:

DON'T RAISE THE TOWER YET!

20' Tower Setup

Loosen the top mast knob and start spreading the three legs. It's easiest to anchor one leg against the ground and pull apart:

Expand the legs as wide as possible and then loosen the lower mast knob:

Lower the center mast pole to the ground and then re-tighten the lower knob:

Lastly, tighten the upper mast knob:

DON'T RAISE THE TOWER YET!

Endzone Equipment Setup

Step 1. Mount the camera head onto the tower.

Be sure to push all the way down. BOTH O-Rings should be fully inserted.

Step 2. Connect the 30-foot Ethernet Cable key ring to the carabiner already attached to eyelet screw

Retrieve your 30ft cable from inside your tower bag

Note: This cable is NOT in the hardcase along with the rest of the equipment, it is in the tower bag. Be sure to look for it thoroughly, we promise we've included it!

Step 2: Connect the Ethernet Cable to the Wireless Head

Connect the Ethernet cable into the port in the bottom of the Pan/Tilt head. Make sure that there is a large loop on the Ethernet cable to ensure the weight of the cable is on the relief hook, and not on the Ethernet port, as shown below.

 

Step 3: Turn your Battery On and tap AC

Step 3: Plug In All Cables as shown

Step 4: Attach the Antenna to the Tower using the Provided Zip-Tie

Important: The filmer can be up to 100’ from the endzone tower with either antenna type. The antenna below is directional so the face of the antenna must always be directed at the filmer.

Step 5: Create a New Game and Test

Next we will create a test game to temporarily test the Wireless Endzone Camera on the field to make sure everything is working:

• If you do not know how to create a new game yet, go to: How To Create and Start a Game.

Once the game is created:

1. If the controls panel is collapsed, tap the arrow to un-collapse it:
   • 
2. Test the motor controls (by default on the right hand of the screen).
3. Test the zoom controls (by default left side of screen).
4. Record a few test clips using the red record button.
   • Note: You will not be able to watch the clips back in the app from the thumbnails at the bottom of the screen unless you pay for the replay license. 

How to Connect the Wireless Endzone Camera to your Replay System

For example Hudl Sideline or Gamestrat.

• See: How to Use the Wireless Endzone Camera with a Replay System

Raising the Tower

1. Loosen top knob and slide pole up.
2. Once you feel the stopper, slide the pole down a few inches.
3. Lock the knob and clip the blue ethernet cable into the large carabiner.
4. Repeat with each pole to reach desired height.

IMPORTANT! - Always keep two hands on tower poles when raising or lowering for safety.

Congratulations, the setup is now complete! 

You may control the system via the iPad up to 100 feet away. Be sure to stay in the antenna's range and avoid obstructions in between the iPad and antenna such as chain link fences, large bodies of people, football sleds, etc.

We're available via Call (or Text) at our Support number directly: 509-204-3270

Or Email us at support@sportscope.com