Endzone Tower Setup
30' Tower Setup
Insert the tower into the base plate with wheels and then extend all 4 locking legs:
Then tighten all 4 knobs:
DON'T RAISE THE TOWER YET!
20' Tower Setup
Loosen the top mast knob and start spreading the three legs. It's easiest to anchor one leg against the ground and pull apart:
Expand the legs as wide as possible and then loosen the lower mast knob:
Lower the center mast pole to the ground and then re-tighten the lower knob:
Lastly, tighten the upper mast knob:
DON'T RAISE THE TOWER YET!
Wireless Camera Setup:
Step 1. Mount the camera head onto the tower.
Be sure to push all the way down. BOTH O-Rings should be fully inserted.
Step 2. Connect the 30-foot Ethernet Cable key ring to the carabiner already attached to eyelet screw
Retrieve your 30ft cable from inside your tower bag
Note: This cable is NOT in the hardcase along with the rest of the equipment, it is in the tower bag. Be sure to look for it thoroughly, we promise we've included it!
Step 2: Connect the Ethernet Cable to the Wireless Head
Connect the Ethernet cable into the port in the bottom of the Pan/Tilt head. Make sure that there is a large loop on the Ethernet cable to ensure the weight of the cable is on the relief hook, and not on the Ethernet port, as shown below.
Step 3: Turn your Battery On and tap AC
Step 3: Plug In All Cables as shown
Step 4: Attach the Antenna to the Tower using the Provided Zip-Tie
Important: The filmer can be up to 100’ from the endzone tower with either antenna type. The antenna below is directional so the face of the antenna must always be directed at the filmer.
Step 5: Verify the Camera is Ready
Next connect your iPad to the Sport Scope wifi SSID:
- Input your password, which can be founder on your router:
Open the menu on the left and tap on Cameras to check the status of the cameras. Verify that you can see the Endzone camera:
Next we will create a test game to temporarily test the Wireless Endzone Camera on the field to make sure everything is working:
- If you do not know how to create a new game yet, go to: How To Create and Start a Game.
Once the game is created:
- Test the motor controls (by default on the right hand of the screen).
- Test the zoom controls (by default left side of screen).
- Record a few test clips using the red record button.
Raising the Tower
- Loosen top knob and slide pole up.
- Once you feel the stopper, slide the pole down a few inches.
- Lock the knob and clip the blue ethernet cable into the large carabiner.
- Repeat with each pole to reach desired height.
IMPORTANT! - Always keep two hands on tower poles when raising or lowering for safety